Product ID:PLIOBOND 20
MSDS Date:03/03/1986
FSC:8040
NIIN:00N008979
MSDS Number: BCRKQ

W.J. RUSCOE COMPANY

485 RUSCOE COMPANY
AKRON, OH 44301

Emergency Phone: 216-253-8148

Info Phone: 216-253-8148

Cage: HO423

W.J. RUSCOE COMPANY

2746 AKRON, OH 44301 US

Telephone: 216-253-8148

Cage: HO423

CALCIUM CARBONATE (MARBLE) (LIMESTONE)

CAS: 1317-65-3

RTECS: EV9580000

Fraction By Weight: 1-5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9192

METHYL ETHYL KETONE (2-BUTANONE) (MEK) (SARA III)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 70-75%

OSHA PEL 200 PPM/300 STEL

ACGIH TLV: 200 PPM/300STEL 9192

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

THE SPECIFIC CHEMICAL IDENTITY OF INGRED 01 & 02 HAS BEEN

RTECS: 9999999ZZ

OSHA PEL N/R

ACGIH TLV: N/R

SYNTHETIC RUBBER

Fraction By Weight: 10-15%

ALKYLPHENOLIC RESIN

Fraction By Weight: 5-10%

LD50 LC50 Mixture:N/K
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MINOR EMBRYOTOXIC/FETOTOXIC EFFECTS
OBSERVED IN RATS EXPOSED TO MEK BY INHAL @ 71000 PPM FOR MOST OF
GESTATION PERIOD.OVEREXP OF ANIMALS TO THIS MATERIAL FOUND TO CAUSE
LIVER,ABNORM,KIDNEY,LUNG & BRAI N DAMAGE.
Explanation of Carcinogenicity:N/K
Effects of Overexposure:EYES:CAN CAUSE SEVERE
IRRIT,REDNESS,TEARING,BLURRED VISION.SKIN:RPTD/PRLNG CONTACT MOD
IRRIT,DEFATTING,DERMAT.EXCESSIVE INHAL:NASAL & RESP
IRRIT,DIZZINESS,WEAKNESS,FATIGUE,NAUSEA,POSS UNCON,& EVEN ASP
HYXIATION.SWALLOWING:CAN CAUSE GASTROINTESTINAL
IRRIT,NAUSEA,VOMITING & DIARRHEA.
Medical Cond Aggravated by Exposure:N/K

First Aid:SKIN:WASH EXPOS AREA WITH SOAP & WATER.REMOVE CONTAM
CLOTHING.LAUNDER BEFORE REUSE.EYES:FLUSH W/ WATER,LIFTING LIDS.GET
MED ATTENTION.INGEST:DRINK 2 GLASSES WATER,INDUCE VOMIT W/ SYRUP OF
IPECAC OR PL ACING FINGER @ BACK OF THROAT.NEVER GIVE ANYTHING TO
UNCON PERSON BY MOUTH.INHAL:REMOVE TO FRESH AIR.IF BREATHING
DIFFICULT ADMIN O*2,IF STOPPED ARTF RESP.KEEP PERSON WARM,QUIET,GET
MED ATTENTION.

Flash Point Method:TOC
Flash Point:23F,-5C
Lower Limits:2%
Upper Limits:N/K
Extinguishing Media:REGULAR FOAM OR CARBON DIOXIDE OR DRY CHEMICAL
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIP .
Unusual Fire/Explosion Hazard:VAPORS HEAVIER THAN AIR & MAY TRAVEL
ALONG GROUND & IGNITED BY PILOT
LIGHTS,FLAMES,SPARKS,HEATERS,SMOKING,ELECTRIC MOTORS,STATIC
DISCHARGE OR OTHER (SEE SUPP)

Spill Release Procedures:SMALL SPILLS:ELIMINATE ALL IGNITION SOURCES &
ELEC SPARKS.ABSORB ON PAPER,VERMICULITE,FLOOR ABSORBANT,TRANSFER TO
HOOD.LARGE SPILLS:ELIM ALL IGNITION SOURCES.PERSONS MUST WEAR PROT
EQUIP.STOP SPILL,DI KE AREA,PUMP LIQ TO TANK/SHOVEL TO CNTNR(SUPP
DATA
Neutralizing Agent:N/K

Handling and Storage Precautions:N/K
Other Precautions:CONTAINERS MAY BE HAZARDOUS WHEN EMPTIED,THEY MAY
CONTAIN RESIDUES (VAPOR,LIQ,&/OR SOLID) ALL HAZARD PRECAUTIONS MUST
BE OBSERVED.

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:PROVIDE SUFFICIENT MECH (GENERAL &/OR LOCAL EXHAUST)
VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:NEOPRENE
Eye Protection:CHEMICAL WORKERS GOGGLES
Other Protective Equipment:TO PREVENT REPEATED OR PROLONGED SKIN
CONTACT,WEAR IMPERVIOUS CLOTHING & BOOTS.
Work Hygienic Practices:N/K
Supplemental Safety and Health
BP:@ 760 MMHG,VP:68F,20C.UNUSAL FIRE & EXPLOSION HAZARDS:IGNITION
SOURCES.NEVER USE WELDING OR CUTTING TORCH ON DRUM BECAUSE PRODUCT
CAN IGNITE EXPLOSIVELY.5 GAL PAILS & LARGER METAL CONTR SHOULD BE G
ROUNDED &/OR BONDED WHEN MATERIAL IS TRANSFERRED.SPILL/RELEASE
PROC:ABSORB REMAINING LIQ,CONTAINERIZE.

Boiling Pt:B.P. Text:176F,80C
Melt/Freeze Pt:M.P/F.P Text:N/K
Decomp Temp:Decomp Text:N/K
Vapor Pres:71 MMHG @
Vapor Density:2.5 AIR=1
Spec Gravity:0.86 @ 68F,20C
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:N/K
Appearance and Odor:LIQUID
Percent Volatiles by Volume:75.80

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:N/K
Hazardous Decomposition Products:CARBON DIOXIDE,& CARBON
MONOXIDE,VARIOUS HYDROCARBONS,NITROGEN CMPDS,HYDROGEN CYANIDE,ETC.

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH
FEDERAL,STATE & LOCAL REGULATION . EVAPORATE SMALL SPILL IN
HOOD,LET VAPOR CLEAR DUCTS.LARGE SPILL:DESTROY BY LIQ
INCINERATION.CONTAM ABSORBANT MUST BE DEPOSI TED IAW FEDERAL,STATE
& LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.